The spine can be removed in different ways, however, before that, it is important to wash the area properly, with soap and water, to prevent the development of an infection, avoiding rubbing, so that the spine does not penetrate deeper into the skin. .
The removal method should be chosen depending on the position of the spine and the depth in which it is located, which can be made with tweezers, adhesive tape, glue or baking soda.
- If part of the spine is on the outside of the skin.
- It can be easily removed with tweezers or a piece of duct tape.
- To do this.
- You must pull the thorn in the direction it was nailed.
To remove a spine from the skin easily and without using needles or tweezers, which can make the moment even more painful, especially if the spine is too deep, you can use a baking soda paste. After a while, the spine exits itself through the same hole through which it entered, since the baking soda causes a slight swelling of the skin that makes the spine grow or shines.
This technique is perfect for children to remove thorns or wood chips from their feet, fingers or any other part of the skin. To prepare the dough, you need:
Ingredients
Preparation mode
Place the baking soda in a small cup and slowly add the water until it has a pasty consistency. Spread over the hole made by the spine and put a bandage or adhesive tape so that the dough does not leave the place and can dry at rest.
After 24 hours, remove the dough and the spine will have come out of the skin. If this does not happen, it may mean that the spine or shine can be very deep in the skin and, therefore, it is recommended to reapply the dough and wait another 24 hours. If the shine is slightly off, you can try removing it with tweezers before using the baking paste again or going to the doctor.
If the column does not come out easily with tweezers or duct tape, you can try applying some glue to the area where the column has entered.
Ideally, use white PVA glue and let dry. When the glue is dry, try to remove it carefully so that the spine comes out.
If the spine is too deep and not on the surface or is covered in skin, you can try using a needle to expose it, slightly piercing the surface of the skin, but very carefully and after disinfecting the skin and skin. Needle.
After exposing the column, you can try using one of the methods mentioned above, to completely delete the column.
See what healing ointments you can apply after removing the spine from your skin.